Steba VG 250 Mode D'emploi page 26

Masquer les pouces Voir aussi pour VG 250:
Table des Matières

Publicité

∙ The appliance must not be operated using a timer or a separate
remote system!
∙ Important: Never immerse the thermostat element or the po-
wer cord into water!
∙ Only use the device for food preparation
∙ Never use the device after a malfunction, e.g. when it was fal-
len down or was damaged in any way.
∙ To avoid any dangers must repairs, e.g. change of a defect po-
wer cord, only be done by our service or an authorised compa-
ny.
∙ Device gets hot. Only transport after it cooled down.
∙ If the appliance is used as a table top, it must be placed on a
even, stable and heat resisting surface (e.g. Not on painted fur-
niture) and keep away (min 70cm) of burnable materials (e.g.
curtains)
∙ Before the first use: Clean all parts and dry them afterwards. To
eliminate the smell of the new item, heat it up for ca. 15min.
The device can smoke a little bit at the beginning.
Attention! Appliance gets hot. Danger of burns! The
temperature of accessible surface may be high when
the appliance is operating.
Safety requirements during usage:
∙ The appliance must be supplied through a residual current de-
vice (RCD) having a rated residual operating current not excee-
ding 30mA.
∙ Use the appliance only when it is assembled.
∙ Do not use the grill plate outside of the appliance and never
immerse into water.
∙ Never leave the appliance outdoors after usage.
∙ Fat and other grill food can spatter and drop. Therefore do not
place the appliance not directly on sensitive surfaces, e.g. Polis-
hed table tops, parquet or carpet.
∙ When using the appliance with stand, be sure that the stand is
standing stable, because the danger of burns when it falls
26

Publicité

Table des Matières
loading

Table des Matières