Bosch PLR 50 C Notice Originale page 42

OBJ_BUCH-2326-003.book Page 42 Thursday, August 20, 2015 8:43 AM
42 | English
Cause
No ® connection
"ERROR" indication in the display
Failure of the Bluetooth® connection
® cannot be activated
Battery voltage too low
Measuring result not plausible
The target surface does not reflect correctly
(e.g. water, glass).
The laser beam outlet 8 or the reception lens 9
are covered.
Wrong reference level set
Obstruction in path of laser beam
1 609 92A 1F3 | (20.8.15)
Corrective Measure
Switch Bluetooth® off and back on
again.
Check the application on your mo-
bile terminal/device.
Check if Bluetooth® is activated on
your measuring tool and mobile
terminal/device.
Check your mobile terminal/de-
vice for overload.
Reduce the distance between
measuring tool and your mobile
terminal/device.
Avoid obstructions (e.g., rein-
forced concrete, metal doors) be-
tween measuring tool and your
mobile terminal/device. Observe
clearance to electromagnetic dis-
turbances (e.g., WLAN transmit-
ters).
Replace batteries/rechargeable
batteries
Cover off the target surface
Make sure that the laser beam out-
let 8 or the reception lens 9 are un-
obstructed
Select reference level that corre-
sponds to measurement
Laser point must be completely on
target surface.
Bosch Power Tools