Bosch PLR 50 C Notice Originale page 35

OBJ_BUCH-2326-003.book Page 35 Thursday, August 20, 2015 8:43 AM
English | 35
Area Measurement
Use area measurement to measure the length and width one after the other as with a
length measurement. The laser beam remains switched on between the two measure-
ments. After the second measurement has been completed, the area will be automat-
ically calculated and displayed.
Press the k button and then select the button for area measurement .
Volume Measurement
Use volume measurement to measure the length, width and height one after the other
as with a length measurement. The laser beam remains switched on between the
three measurements. After the third measurement has been completed, the volume
will be automatically calculated and displayed.
Press the k button and then select the button for volume measurement .
Addition/Subtraction of Lengths, Areas, Volumes
Use addition/subtraction of lengths, areas or volumes to measure lengths, areas or
volumes and to automatically add or subtract them (e.g. helpful when calculating ma-
terials).
Press the k button and then select the button for length calculation or area
calculation or volume calculation .
Use the button to switch between "+" and "–" or to start a new calculation. To
complete the addition/subtraction, press the measuring button 1.
3 3
Values above 9999999 m or below –999999 m cannot be shown; "ERROR" ap-
pears on the display.
Indirect Distance Measurement
Note: Indirect distance measurement is always less accurate than direct distance
measurement. For application-related reasons, measuring errors can be greater than
with direct distance measurement. To improve measuring accuracy, we recommend
placing the measuring tool against or on a firm surface.
The indirect distance measurement is used to measure distances that cannot be
measured directly because an obstacle would obstruct the laser beam or no target
surface is available as a reflector. This measuring procedure can only be used in ver-
tical direction. Any deviation in horizontal direction leads to measuring errors.
For indirect length measurements, three measuring modes are available. Each meas-
uring mode can be used for determining different distances.
Bosch Power Tools 1 609 92A 1F3 | (20.8.15)