BaByliss PRO MiraCurl SteamTech BAB2665SE Mode D'emploi page 14

INSTRUCTIONS FOR USE
• Ensure hair is dry and combed
through.
• Plug the styler into a 230V outlet.
• Slide the temperature switch to
the required heat setting.
• The styler is ready for use when
the ON indicator light has stopped
flashing.
• Turn the steam function on if de-
sired. Refer to "Steam function"
and "Filling the water reservoir"
sections.
• There are 3 time settings; choose
the optimum setting for your hair
type. Alternatively, switch the
time setting to 0.
• Select the curl direction by slid-
ing the control to either position
L, R or A.
• Separate a section of hair that is
no wider than 2.5cm (Figure A).
Ensure that the section is clean,
dry and combed through.
• Please note the styler must be
positioned into the hair with the
opening of the curl chamber fac-
ing toward the head (Figure B).
• Position the styler where you
want the curl to start. The hair sec-
tion must be straight, and placed
neatly through the center of the
styler (Figures C and D).
• Once the hair is in place, let go
of the hair section and close the
handle to allow the hair to be
automatically taken into the curl
chamber (Figure E).
NOTE: If you continue to hold
the hair section after closing the
handle the MiraCurl™ SteamTech
will stop and beep to indicate that
you must release the tension on
the hair.
If you have taken too much hair,
or hair is not neatly going through
the center of the appliance, the Mi-
raCurl™ SteamTech will again stop
and beep to indicate a problem.
This safety feature ensures there
will be no tangles.
• The hair is automatically drawn
into the ceramic curl chamber
where it is softly held and heated
from all directions to effortlessly
form the curl.
• If you are using the timer setting,
the automatic beep indicator will
14