Filling The Water Reservoir - BaByliss PRO MiraCurl SteamTech BAB2665SE Mode D'emploi

FILLING THE WATER RESERVOIR:

• To remove the water reservoir, lift
the edge up slightly then pull it
out of the unit.
• Open the black rubber cap in
back of reservoir and fill with
demineralized water.
• For your safety, turn the machine
off when removing, filling or in-
stalling the water reservoir back
onto the unit
• Put the rubber cap back on, mak-
ing sure it's completely sealed
• Lock reservoir back onto the unit
(you should hear a "click").
1
2
Removable
water
reservoir
(Fill with
deminera-
lized water
only)
AUDIO OFF SETTING
You can turn off the automatic
beep indicator if it is not required
by sliding the timer switch to 0.
NOTE: When the 0 setting is se-
lected, there will be no beep indi-
cator to advise when to release the
styler. Take extra care when using
this setting.
CURL DIRECTION SETTING
(Right/Left/Alternate)
Use the curl direction control to
choose either a uniform or natural
finish. Select the curl direction by
sliding the switch to either left (L)
or right (R) or alternate (A).
(L) starts the curl to the left, coun-
terclockwise.
(R) starts the curl to the right, clock-
wise.
You can also select the opposite
direction on each side to create a
symmetrical look.
When styling the left side of the
hair, slide the curl direction switch
to the left position (L).
When styling the right side of the
hair, slide the switch to the right
position (R). This ensures that the
curl sits toward the face on both
sides of the head and will give a
more uniform style.
For a more natural look, select the
alternate setting (A). This will alter-
nate the direction after each curl.
13