13 Triggering control (auto-flash)
The camera prevents the triggering of a flash if the ambient light level is suffi-
cient for an exposure in the normal mode. The exposure is then completed with
the shutter speed given in the display or viewfinder of the camera. The trigge-
ring control is activated when the flash-ready signal in the camera's viewfinder
is extinguished. In this event no flash is fired when the camera's shutter is trip-
ped.
On various cameras the triggering control only works in the Program "P" Mode
and in the Shutter Priority Mode "S" (see operating instructions for the camera).
The triggering control can be deactivated on some camera models:
• To do so, press and hold down the flash button
shooting (see camera manual).
The flash-ready signal will again be displayed in the camera's viewfinder when
the shutter release is lightly touched. The camera selects a suitable shutter
speed/aperture combination and a flash is fired when a picture is shot.
14 Care and maintenance
Remove dust and grime with a soft dry cloth or silicon-treated cloth. Do not use
cleaning agents as these may damage the plastic parts.
14.1 Firmware updates
The firmware version of the flash unit is shown in the display if the
mode button
The flash unit's firmware can be updated through the USB port
to the technical requirements of future cameras (Firmware Update).
For more information, visit the Metz homepage at www.metz.de.
on the camera during
14.2 Reset
The flash unit can be reset to the factory settings when
delivered.
• Press the „Mode" button for ca. 5 seconds.
After ca. 5 seconds „rES" (= Reset) is shown in the
display and the flash unit is reset to the settings as delivered..
☞
14.3 Flash capacitor forming
The flash capacitor built into the flash unit undergoes physical change if the unit
is not switched on for a prolonged period. For this reason it is necessary to
switch the unit on for approximately 10 minutes at least once every three
months. The power supplied by the power source must be sufficient to cause the
flash readiness indicator to light up no more than one minute after the flash unit
is switched on.
is pressed while the camera is being switched on.
This will not affect the firmware updates for the flash unit.
and adjusted
rES
rES
95