Auto Off For The Flash Unit - Metz 50 AF-1 Mode D'emploi

Checking remote flash operation
• Remove the slave flash unit from the camera and fold open the camera's inte-
grated flash unit.
• Place the slave flash unit in the position required for the subsequent shot. Use
the flash unit mounting foot S60 (special accessories; see 17) to support the
slave flash unit.
• Wait until the slave flash unit and the camera's integrated flash unit are ready
for operation. If the slave flash unit is not flash-ready, its AF meter flash
starts flashing.
• Trigger a test flash on the camera, e.g. via the AEL button (dependent on
camera type; see camera operating instructions).
• The slave flash unit gives a delayed response in the form of a test flash. If the
slave flash unit does not trigger a test flash, correct the position of the slave
flash unit to enable it to receive the light sent by the controller flash unit or
reduce the distance between the controller and slave flash units.
• Once successful test flash operation has been checked, you can now start
taking the shots..

9.3 Auto OFF for the flash unit

The auto OFF for the flash unit can be set so that it occurs after 10 minutes, 1
minute or is deactivated.
Setting procedure
• Press button combination „Select" until
the symbol flashes.
• Apply the setting desired with the buttons + and –.
– When „10min" is displayed, Auto OFF
function will be activated after `
10 minutes.
– When „1min" is displayed, the Auto OFF
will be activated after 1 minute.
– When „OFF" is displayed, the Auto OFF is
deactivated.
The setting takes effect immediately.
After about five seconds the display stops flashing and the setting is saved
automatically.
After activation of the auto OFF the display shows
OFF
10min
10min
OFF
10min
.
89