Functioning; Preparing For Use; Installing The Product; Setting Up The Product - LIVARNO LUX IAN 292066 Instructions D'utilisation Et Consignes De Sécurité

Functioning

The solar cell installed in the product converts sunlight into
electrical energy and stores it in 1 Ni-MH battery. Switches on
the light as it begins to get dark. The in-built light-emitting di-
odes are a very long-life and energy-saving light source. The
light duration depends on the amount of sunlight, the angle of
light on the solar cell and the temperature (the battery capac-
ity is temperature-dependent). A vertical angle of light at tem-
peratures above the freezing point is ideal. The battery does
not achieve maximum capacity until after several charge and
discharge cycles.

Preparing for use

Installing the product

Install the product in accordance with Figures A, C, D:
1. Rotate the solar cell housing
lamp shade
2. Move the ON / OFF switch
switch the light on.
3. Insert the solar cell housing
tighten by turning it clockwise.
4. Place the light on to the pole
5. Take out the ground stake
it into the pole
Fig. C).
6. Your product is ready for use (see Fig. D).

Setting up the product

Insert the assembled product far enough into the ground
(lawn, flower bed) for it to be stable.
Make sure you keep proper footing and balance at all
times. Do not use any force when assembling or setting-up
the product, e.g. hammer blows. This will damage the
product. In order to achieve the best result, set the product
up in a place where the solar cell will get direct sunlight
for as long as possible.
Make sure that the solar cell is not influenced by any
other source of light such as yard or street lighting as
otherwise the light will not come on in twilight.
The light automatically switches on in twilight conditions
and off again when normal outdoor lighting conditions
return.
(see Fig. A).
2
1
4
with the tip facing downwards (see
3
anticlockwise out of the
1
into the ON position to
5
into the lamp shade
.
3
from the pole
and
2
and insert
3
GB/IE/NI 9