Sony SU-WL500 Mode D'emploi page 9

Masquer les pouces Voir aussi pour SU-WL500:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
When using an electric screwdriver, set the torque setting
to approximately 2 N·m {20 kgf·cm}.
Do not lift the Mounting Hook before the screws (two
screws each for left/right) are secured. This may distort
the Mounting Hook or the TV cabinet.
2
Referring to the Screw and Hook
locations diagram/table on
page 13, determine the screw
positions, and secure the Mounting
Hook to the rear of the TV.
1 Secure the Mounting Hook to the rear of the TV
temporarily, using the supplied four screws
(+PSW6 × 16).
2 Be sure that both screws are securely tightened with
equal torque strength to the rear of the TV.
Screw
(+PSW6 × 16)
Square hole
Align the tab on the rear of the Mounting Hook
with the square hole on the rear of the TV as in
the illustration below.
Tab
Square hole
Note
Be sure not to use any screws other than the supplied ones
(+PSW6 × 16) when securing the Mounting Hook.
Mounting
Hook
3
Adjust the angle of the Mounting
Hook using the supplied
hexagon wrench.
When installing the TV parallel to the wall (0 degrees),
adjustment of the Mounting Hook angle (procedures
1 and 2 below) is not necessary. Make sure that each
arm base X is screwed in securely.
1 Remove the two screws from the arm base X of the
Mounting Hook. Choose the holes corresponding to
the desired angle (5, 10, 15 or 20 degrees).
2 Adjust the angles of the top Y and bottom Z arm
to fit the corresponding hole, and firmly secure each
arm using the two screws removed in the previous
procedure 1.
Hexagon wrench
Notes
• Be sure to adjust the right and left arms to the same angle.
• Make sure that the two arm bases are screwed in securely.
CAUTION
Be careful not to pinch your fingers when adjusting the angle
of the Mounting Hook.
Notes on the adjustment angles
• When installing TV models other than those
specified on page 2 (depending on the model's
size and dimensions, etc.), the adjustment angles
listed (0, 5, 10, 15, 20 degrees) for the arms may
be limited.
• For the available adjustment angles of the arms
when installing TV models other than those
specified on page 2, refer to their operating
instructions, or the supplied leaflet.
9
(GB)

Publicité

Table des Matières
loading

Table des Matières