Using The Remote Commander - Sony DSC-1024G Mode D'emploi

Using the remote commander

S
ON/OFF
COMMAND MODE selector
This unit accepts wireless or wired remote commanders for
Sony monitors, TVs and projectors.
Setting the type of the remote commander
Set the COMMAND MODE selector according to the type of
the remote commander.
TV: Sony monitors' or TVs'
commander
PJ: Sony projectors' commander
OFF: When not using the remote
commandder, set to this
position to avoid malfunction.
Available remote commander operations
The following operations can be controlled by the remote
commander.
• Power on/off
• Input selection
• Picture adjustments: contrast, phase and chroma
• On-screen display on/off (only for video monitors and TVs)
• Menu operations (See the right column.)
• Direct memory loading (See the right column.)
The available operations and the buttons to be used for each
operation are limited depending on each remote commander.
See the table below.
Remote commander model
COMMAND MODE setting
Input selection INPUT SELECT 1
INPUT SELECT 2
INPUT SELECT 3
Menu operation MENU
ENTER
CENT ◊
CENT √
Picture adjustment CONTRAST
CHROMA
PHASE
40
TV
IN NTSC PAL
PJ
OFF
DISPLAY TEST LINE OUTPUT OUT NTSC PAL
COMMAND
ON/OFF PATTERN DOUBLER FORMAT GEN-LOCK
MODE
MENU
CENT
ENTER
TV
PJ
OFF
COMMAND
MODE
RM-854
TV
LINE1
LINE2
LINE3
MENU
ENTER
>
.
CONTRAST
CHROMA
PHASE
Remote sensor
OVER FLOW
SIGNAL FORMAT
31.5k 37k 48k 64k OTHERS
31.5k 37k 48k 64k
CHROMA PHASE CONTRAST
SIZE
Direct memory loading
The remote commander can quickly call up the adjustment
data stored in the memory.
1 Press buttons 7, 7, 7 and ENTER on the remote
commander in sequence at intervals of one second.
The "MEMORY LOAD READY" appears on the screen.
2 Select the memory number (1 to 5) you want to call up
using the number button.
The converter is adjusted to the selected memory data.
To cancel the operation
Press buttons 0, 0, 0 and ENTER on the remote commander in
sequence at intervals of one second. The "MEMORY LOAD
EXIT" appears on the screen.
The direct memory load operation is also cancelled by turning
off the unit.
Note
Be sure to press buttons 7, 7, 7 and ENTER, or 0, 0, 0 and
ENTER at intervals of about one second.
If more than 3 seconds elapse between two presses, the
operation will be cancelled. In this case, start again.
Menu operation using the remote commander
The menu screens for the remote commander are different
from those for the main unit.
When you press the menu button (MENU, PAGE or ?) on the
remote commander once or twice, the GEOM MENU or
COLOR MENU appears respectively.
Select the item with the >/. button and press the enter button
(ENTER, / or M SEL) on the remote commander. Then
adjust the selected item using the >/. button.
RM-1271 RM-PJ1292
PJ PJ
VIDEO VIDEO
A A
B B
PAGE or ? PAGE or ?
/ /
> >
. .
CONTR CONTR
COLOR COLOR
HUE HUE
OPEN SCAN CONVERTER DSC-1024G
INPUT SELECT
STILL
APERTURE
1 2 3
ZOOM
RM-PJ350 RM-PJC520
PJ PJ
VIDEO1 1
VIDEO2 2
RGB 3
PAGE or ? PAGE
/ M SEL
> >
. .
CONTR CONTR
COLOR –
HUE –