Inserting The Batteries; Step 2: Setting Up The Remote Commander; Using The Remote Commander - Sony SVO-1320P Mode D'emploi

Step 2: Setting up
the remote
commander
Notes
• With normal use, the
batteries should last for
approximately three to six
months.
• If you do not use the
remote commander for an
extended period of time,
remove the batteries to
avoid possible damage
from battery leakage.
• Do not use a new battery
with an old one.
• Do not use different types
of batteries together.
SEQ. PLAY
SENSOR REC
6 -EN
Getting Started

Inserting the batteries

Insert two R6 (size AA) batteries by matching the + and – on the
batteries to the diagram inside the battery compartment.

Using the remote commander

You can use this remote commander to operate this VCR and a Sony
TV. Buttons on the remote commander marked with a dot (•) can be
used to operate your TV.
Remote sensor
To operate Set TV / VTR to
the VCR VTR and point at the remote sensor on the VCR
a Sony TV TV and point at the remote sensor on the TV
Before you control the VCR with the remote commander ...
Check the following:
• The SEQ. PLAY switch is set to OFF.
• The SENSOR REC switch is set to OFF. (SVO-1520P only)
If the settings of these switches are incorrect, the remote commander
does not function.
TV / VTR