Getting Started; Using The System - Luvion GRAND ELITE Guide D'utilisation

GETTING STARTED

Parent unit
Determine whether you will be using the docking station, or connecting the cables directly
to the parent unit before installation.
1.
Carefully unpack the parent unit.
2.
Place the parent unit (in the docking station) in a place that has clear reception with
the baby unit.
3.
Plug the DC 5V power adapter into the DC 5V input at the side of the parent unit or
at the back of the docking station. Plug the power adapter in the wall socket. When
using the docking station, place the parent unit in the docking station.
The parent unit will start to charge; the charging indication LED will now turn red.
4.
Leave the parent unit to charge prior to the first time use until the built-in
rechargable battery is fully charged. The charging indication LED will turn green
when the battery is fully charged.
Note:
Do not remove the power adapter during the initial charging process. After the initial
charge, charge the parent unit as required.
If you wish to view the baby unit video on a larger screen, connect the included RCA
cable to a TV or monitor. Connect the Video IN (yellow) and the Audio IN (white)
plugs to the TV or monitor. Connect the other plug to the AV OUT input located at the
side of the parent unit.
Note:
The use of the AV output is for convenience only. When it is used in combination with
a large screen TV or monitor, the video might be grainy as the camera limits the video
resolution to VGA (640 x 480 pixels). This is not a product defect.
For the best video quality use the PIP (Picture in Picture) function of your TV or monitor. It
enables you to concurrently watch TV and look at the video of the parent unit.
baby unit
Before installing the baby unit, carefully plan where and how it will be positioned, and where
you will route the cable of the power adapter.
Before starting permanent installation, verify the reception of the baby unit video on the
parent unit. Verify this when both the baby unit and the parent unit are placed in their
preferred positions.
8
1.
Carefully unpack the baby unit.
Note:
If you are installing baby units that do not come with the initial system (separately sold
baby units), please look at the pairing baby units section of this manual for details on
installation.
2.
Mount the baby unit on the wall or put it on a cabinet, table or shelf. To mount the
baby unit on the wall, mark the position of the 2 screw holes on the wall. Drill the
holes and insert the included wall plugs and screws. Firmly attach the baby unit on
the wall by placing the base over the screws and pushing it downwards.
3.
Point the camera of the baby unit towards the area you want to monitor.
The baby unit can be powered by the included power adapter or by 4AA batteries
(not included).
Power adapter
Connect the DC 9V power adapter to the DC 9V input at the back of the baby unit.
Plug the power adapter in the wall socket.
Batteries
Remove the battery pack cover off the base of the baby unit. Place 4AA batteries into
the battery pack. Make sure to correctly lin up the positive and negative poles of the
batteries.
Place the battery pack cover back on.
Note:
We advise you always to use the main power for the baby unit Should there be no main
power around, we advise you to use non-rechargable batteries for the baby unit. Should
you decide to use rechargeable batteries, make sure that the power adapter is not
connected to the camera. The baby unit has no charging function.

USING ThE SySTEM

The video of the baby unit will be displayed on the
screen of the parent unit when both are switched on.
1. Signal indicator
2. Channel indicator
LUVION
Premium Babyproducts
Cam1 2
1
9