Getting Started - Luvion PRESTIGE TOUCH 2 Manual D'instructions

32

GETTING STARTED

INSTALLING THE PARENT UNIT MONITOR
1. Carefully unpack the parent unit (monitor).
2. Connect the power adapter to the parent unit and power socket. The parent unit will start charging;
the indication LED will now light up (red). This LED will turn green when the parent unit is fully charged.
During fi rst use, please allow the unit to completely charge to ensure optimal battery capacity.
MIC
: C
NOTE HARGE THE PARENT UNIT COMPLETELY BEFORE FIRST USE
3. Press and hold the on/off button. The screen will now show the Luvion introduction screen.
MIC
INSTALLING THE BABY UNIT CAMERA
Before you install the baby unit (camera), carefully plan where and how you want to position it. Make sure
that you take in account the length of the power cable and the position of the power socket, because the
baby unit (camera) needs to be connected to the power grid.
1. Carefully unpack the baby unit (camera).
2. Place the baby unit in the preferred position. You can place the baby unit on a table/cabinet, or you
canmount it on a wall or ceiling. You can use the mounting frame to mount the camera on a wall or
ceiling. With the provided plugs and screws.
: Before permanently installing the baby unit (camera), make sure that the wireless connection
NOTE
between the baby unit and parent unit is su cient. Verify this when both the parent unit and baby unit are
placed in the positions from which you would like to use them.
: Avoid installing the baby unit near walls or other obstruction between the baby and parent unit. For a
NOTE
good sound sensitivity and image it is recommended to place the baby unit between a 1,5-3m distance .
1
4 2
3
1
4 2
3
.
LUVION
MIC
1
4 2
3