User Access Mode; Commissioning; Regulation Of Airfl Ow (Fan Speed) - S&P CADB-N TERMO-REG Instructions De Montage Et D'utilisation

10.1. USER ACCESS MODE

Accessing in this mode, you have access to the following functions:

1. Commissioning

2. Regulation of Airfl ow (Fan speed)
3. Regulation of Temperature (Versions-DI and DC)
4. Actuating the By-pass
10.1.1. Commissioning
Before commissioning, it should perform the following checks:
• Make sure that the inside the equipment has not foreign bodies and all components are fi xed
in place.
• Check manually that the fan does not touch the walls.
• Verify that the inspection hatch is closed.
ATTENTION:
If the fan valves are not canalized must be installed a safety adequate net.
Check the electrical connection is correctly earthed.
The electrical connection must be performed by qualifi ed personnel.
1. Ensure that the equipment is fully wired and protected
in accordance with current legislation in the country
where the installation is performed.
2. Turn on the main switch on the outside of the electrical
cabinet.
3. Press the ON/OFF button on the remote control.
10.1.2. Regulation of airfl ow (fan speed)
By pressing the FAN button it is possible to select between low,
medium, high speed or automatic speed*.
A LED indicates the selected speed.
LOW
* You can have automatic speed based on air quality. To do this, connect an air quality sensor TERMO-REG
SCO2 (accessory) and the "air quality sensor" parameter must be activated. See installer mode.
MEDIUM HIGH
46
AUTO