Using The Led Torch; Switching The Mini Jumpstarter On And Off; Test Procedure For The Battery Of The Vehicle Using The Cigarette Lighter; Test Procedure For The Vehicle Battery Charging System Using The Cigarette Lighter - Absaar AB-MJS270 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN

8.4 Using the LED torch.

- Press the power supply button (2) for 2 seconds in order to switch on theMini
Jumpstarter.
- Press once on the control button of the LED torch(6) for 1 second in order to activate the
flash mode of the torch. Then pressit again for 1 second in order to activate the torch in
continuous mode.
8.5 Switching the Mini Jumpstarter on and off.
- Press the power supply button (2) for 2 seconds in order to switch on theMini
Jumpstarter.
- Press the power supply button (2) for 2 seconds in order to switch on theMini
Jumpstarter.
Note
: The outlet connections of the Mini Jumpstarter (10) deliver a small current all the
time, even if the Jumpstarter is switched off. Always make sure that this outlet is
properly protected using the protective caps.

8.6 Test procedure for the battery of the vehicle using the cigarette lighter.

- Press the power supply button (2) for 2 seconds in order to switch on the Mini Jumpstarter.
- Use the Micro USB/cigarette lighter connector cable.
- Connect the micro USB connector of the cable to the(8) "CHARGE/TEST" input of the Mini
Jumpstarter.
- Connect the cigarette lighter connector in the vehicle.
- Make sure that the cigarette lighter connector of your vehicle is powered
(See the user manual of your vehicle).
- Do not start up the engine.
- Press the test button (5) once; the logo will be displayed on the LCD screen
the battery voltage of your vehicle and its status: Low,Mid or Full.

8.7 Test procedure for the vehicle battery charging system using the cigarette lighter.

- Press the power supply button (2) for 2 seconds in order to switch on the Mini Jumpstarter.
- Use the Micro USB/cigarette lighter connector cable.
- Connect the micro USB connector of the cable to the(8) "CHARGE/TEST" input of the Mini
Jumpstarter.
10
as well as

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières