Description And Indications Of The Led; Procedure For Using The Start-Up Aid - Absaar AB-EJS260 Mode D'emploi

Operating instructions
4) DESCRIPTION AND INDICATIONS OF THE LEDs
Indicator of the
Description
charge status of
and indication
the internal battery
of the "Power"
power supply
button
Description
of the charge
status levels
when recharging
the internal
battery of the
Jumpstarter
Description
of the charge
statuses when
recharging
the internal
battery of the
Jumpstarter
Others
Torch LED
lighting

5) PROCEDURE FOR USING THE START-UP AID

• Ensure that the EJS-260 is fully charged
• Connect the red clamp with the positive and the black clamp with negative pole of the battery
• Insert the jump leads into the outlet
• Start the car (The attempt is only allowed to last 5 seconds, after each attempt you have
to wait 60 seconds to cool down the internal battery)
• Remove the jump leads out of the outlet
• Disconnect the clamps from the battery
• Recharge the EJS-260
Press the power supply button
the internal battery. When charging, the LEDs light up and flash one after the other
until fully charged. This is indicated when all the LEDs are lit.
The LEDs indicate the charge status of the internal battery in relation to the
(3)
voltage of the internal battery
0%-25%
25%-50%
50%-75%
75%-99%
100 % (end of charging process)
Press the power supply button
of the internal battery and automatically switches itself off after 30 seconds if no
charge is detected.
100%-75%
75%-50%
50%-25%
25%-1%
1%- 0%
0%
1- Click the "power" power supply button
to light the working light
2- click again to activate the warning light
the warning light flashing
3- click again to activate led torch
4- click again to switch off the whole unit
Any time you can turn off the unit by pressing 3 seconds the on/off button
(8)
(8)
9
, the LED indicator
(6)
LED N 1 flashes
o
LED N 1 und N
o
LED N 1, N
o
LED N
o
All the LEDs are lit continuously.
, the LED indicator
(6)
All the LEDs are lit.
LED N 1, N
o
LED N . 1 and N
o
LED N 1 is lit
o
LED N 1 flashes
o
All the LEDs are off
once to turn on the device, click a second time
(6)
.
(9)
solid mode, and another time
(10)
, and another time the led sos strobe light
(1)
indicates the charge status of
(3)
2 flash
o
2 und N 3 flash
o o
1, N 2, N 3 und N 4 flash
o o o
indicates the charge status
(3)
2 and N 3 are lit
o o
. 2 are lit
o
(6)
ABSAAR