Lcd Screen; Procedure For Using The Start-Up Aid - Absaar AB-MJS270 Manuel De L'utilisateur

6. LCD screen:

- After pressing the power button for 2 seconds, the LCD screen of the Mini Jumpstarter
displays the available power of the internal battery (%).
- After each start-up attempt, the LCD screen displays a stopwatch indicating the waiting time
in seconds before the next start-up attempt. This is the period needed for the Mini
Jumpstarter to cool down.
- The LCD screen can also display the following breakdown codes:
F01
F02
F03
F04
F05
F06
No external battery detected or external battery voltage too low (less
- Test Mode: During this mode, the LCD screen displays the result of the battery/alternator
test.
7. Direct connection function (Override):
The direct connection function (Override) is only designed for starting an engine without a
battery or with a voltage less than 2 Volts.
Caution: This function disconnects the short-circuit protection system!

8. Procedure for using the start-up aid:

Important : 1. Always make sure that the capacity of the battery of the Mini Jumpstarter is
above 75%.
2. Recharge the internal battery of the Mini Jumpstarter EVERY 3 MONTHS, even
if you have not used the Mini Jumpstarter.
3. Always make sure that clamps and the connector are properly connected
before attempting to start up of the vehicle.
4. If the engine does not start up at the first attempt, wait for 1 minute before
trying to start it up again.
5. After use in start-up aid mode, fully recharge the internal battery of the
Jumpstarter as quickly as possible.
Discharged internal battery
Temperature of the internal battery too low
Temperature of the internal battery too high
Surcharge
Inversion of polarity
than 2 Volts) or not connected.
7
EN