Description And Indications Of The Led; Procedure For Using The Start-Up Aide - Absaar AB-MJS400 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating instructions
4) DESCRIPTION AND INDICATIONS OF THE LEDS
Indicator of the
Description
charge status of
and indication
the internal battery
of the "Power"
power supply
button
Description
of the charge
status levels
when recharging
the internal
battery of the
Mini Jumpstarter
Description
of the charge
statuses when
recharging
the internal
battery of the
Mini Jumpstarter
Others
Torch LED
lighting
5) PROCEDURE FOR USING THE START-UP AID
• Ensure that the MJS-400 is fully charged
• Connect the red clamp with the positive and the black clamp with negative pole of the battery
• Insert the jump leads into the outlet (9)
• Start the car (The attempt is only allowed to last 5 seconds, after each attempt you have to wait 60 seconds to cool down the
internal battery)
• Remove the jump leads out of the outlet (9)
• Disconnect the clamps from the battery
• Recharge the MJS-400
Press the power supply button
the internal battery. When charging, the LEDs light up and flash one after the other
until fully charged. This is indicated when all the LEDs are lit.
The LEDs
(4)
voltage of the internal battery
0%-25%
25%-50%
50%-75%
75%-99%
100 % (end of charging process)
Press the power supply button
of the internal battery and automatically switches itself off after 30 seconds if no
charge is detected.
100%-75%
75%-50%
50%-25%
25%-1%
1%- 0%
0%
1- Click the "power" power supply button
2- Click again to activate the S.O.S. mode
3- Click again to activate the stroboscopic mode
4- Click again (or double click) to switch off the torch
(1)
The torch
(1)
indicate that the internal battery's power is weak.
, the LED indicator
(5)
indicate the charge status of the internal battery in relation to the
, the LED indicator
(5)
cannot be switched on when charging the battery or when the LEDs
9
indicates the charge status of
(4)
LED N
.1 flashes
o
LED N
.1 und No.2 flash
o
LED N
.1, N
.2 und No.3 flash
o
o
LED N
. 1, N
.2, No.3 und No.4 flash
o
o
All the LEDs are lit continuously.
indicates the charge status
(4)
All the LEDs are lit.
LED N
. 1, N
. 2 and N
. 3 are lit
o
o
o
LED N
. 1 and N
. 2 are lit
o
o
LED N
. 1 is lit
o
LED N
. 1 flashes
o
All the LEDs are off
for more than 3 seconds to light the torch
(5)
.
(1)
ABSAAR
(1)
(4)

Publicité

Table des Matières
loading

Table des Matières