Phonocar VM 051 Notice De Montage Et D'emploi page 7

Table des Matières

Publicité

Funzioni di base • Basic Operation
IT
ACCENSIONE/SPEGNIMENTO
1. Premere brevemente
2. Premere
per più di 2 secondi per spegnere l'unità.
SILENZIAMENTO AUDIO
Premere brevemente
Note: • Regolando il volume quando l'unità è in silen-
ziamento, l'audio viene ripristinato.
REGOLAZIONE VOLUME
Ruotare la manopola o premere i tasti
VOL+ e VOL- sul telecomando per re-
golare il volume.
SELEZIONE SORGENTE DA RIPRODURRE
Metodo 1 • Premere brevemente il tasto SRC sul fron-
talino o sul telecomando fino a visualizzzare la sorgente
da riprodurre.
Metodo 2 • Premere per oltre 2 secondi
il tasto SRC sul frontalino o sul teleco-
mando fino alla visualizzazione del menù
sorgenti.
Usare i tasti frecce per muoversi
nel menù e confermare la sele-
zione con il tasto OK.
Note: • Non cambiare sorgente
dopo la conferma della sele-
zione, l'unità impiega qualche
secondo per iniziare la ripro-
duzione, attendere fino alla
visualizzazione sul display della
sorgente.
FRENO A MANO
1. Se il cavo 'PRK SW' è colle-
gato al freno a mano, la visualizzazione sullo schermo
dipenderà dallo suo stato.
2. Quando l'auto è in movimento e si riproduce un fil-
mato, sul display compare la scritta "DO NOT WATCH
VIDEO WHILE DRIVING". Il messaggio avvisa il gui-
datore che non può guardare il video in movimento,
mentre i passeggeri posteriori possono continuare la
visione se l'unità è collegata ad un monitor da tetto o
poggiatesta.
FASE DI RETROMARCIA
Quando è presente la retrocamera l'unità passa auto-
maticamente alla visualizzazione sul display di quest'ul-
tima all'innesto della retromarcia.
L'unità ritornerà nella visualizzazione normale appena
verrà ripristinata la marcia avanti.
per accendere l'unità.
per silenziare l'audio.
GB
TURN ON/OFF THE POWER
1. Press
to turn on the unit.
2. Press
more than 2 seconds to power off.
MUTE
Press briefly to cut the sound.
Note: • Doing the operation above again or
adjusting volume will release muting.
ADJUST THE VOLUME
Rotate the knob on the panel or press
VOL +/- on the remote control to increase
or decrease the volume.
PLAYING SOURCE SELECTION
Method 1 • Short press the SRC button on the panel
or remote control to cycle through all the available
sources.
Method 2 • In any mode, long press the
SRC button on the panel or remote control
to enter main source menu, then use na-
vigate button to select the desired mode,
monitor will be controlled by driving status, system
setup and input video sources.
2. When the car is moving ahead, if the video disc is
played, the screen appears "DO
NOT WATCH VIDEO WHILE DRIVING". The above
warning screen will prevent the driver watching ima-
ges. The passengers at the rear seats can watch
normally.
WHEN REVERSE DRIVING
If the rear view video camera is connected, the unit
automatically switches to CAMERA
source during reverse driving. The unit returns to the
original work mode after the reverse
driving is done.
7
and press OK to confirm.
Note: • You should stop
switching when the playing
source you desired has been se-
lected and
wait for some seconds, the unit
will auto enter the playing source
mode you have selected.
PARKING BRAKE
1. If 'PRK SW' cable is connected
to hand brake switch, the video
display of the TFT
IT/GB

Publicité

Table des Matières
loading

Table des Matières