Programme Progress Display - Zanussi ZWG 3144 Notice D'utilisation

5 "Départ différé/Start uitstel" (Delay
start) button
This button makes it possible to delay the starting of
the washing programme by 12, 8, 4 and 2 hours. The
delay you have selected is indicated by the coming
on of the corresponding light.
You must select this option after you have set the
programme and before you press the START
PAUSE button.
You can cancel the delay time at any moment,
before you press the START/PAUSE button.
If you have already pressed the START/PAUSE
button, and you wish to cancel the delay time,
proceed as follows:
• set the washing machine to PAUSE by pressing
the START/PAUSE button;
• press the DELAY button once, the light relevant to
the selected delay goes off;
• press the START/PAUSE button again.
Important!
• The selected delay can be changed only after
selecting the washing programme again.
• The door will be locked throughout the delay time
If you need to open the door, you must first set the
washing machine to PAUSE by pressing the
START/PAUSE button.
Wait approx. two minutes before opening the door
to give the electric locking mechanism time to
release it.
After closing the door, press the START/PAUSE
button again.
The delay start cannot be selected with SPIN R
and DRAIN Q programmes.

6 Programme progress display

When you choose the delayed start, the light
relevant to the selected delay lights up.
After the machine has started, the remaining time is
shown by the corresponding indicator light.
8 H
4 H
2 H
Fin
Einde
●
WASHING: when this light comes on this
means that the machine is performing the
washing programme.
●
Fin/Einde (END) = end of programme
The END pilot light flashes in the event of operating
problems:
- 4 flashes = the door has not been closed
- 2 flashes = the machine does not empty
- 1 flash = the machine does not fill
To eliminate the problem, see paragraph "Something
not working".
7 Programme selector dial
The selector is divided into 5 sections:
• Cotton
• Synthetic
• Delicate
• Wool/Handwash
• Special programmes
O Reset programme/OFF
The selector dial can be turned either clockwise or
anticlockwise.
At the end of the programme the selector dial
must be turned to position O.
Attention!
If during a washing programme the selector dial is
turned to another programme, the pilot lights of the
programme progress display start to flash. The
machine will not perform the new selected
programme.
67