CEMB SM1100 Manuel D'utilisation page 14

part n. 446237
WARNING
NEVER EXCEED 40
PSI WHILE SEATING
BEADS.
NEVER
EXCEEDTIRE
MANUFACTURER
RECOMMENDED
PRESSURE AFTER
SEATING BEADS.
NEVER LEAN OR
REACH OVER TIRE
OR RIM DURING
INFLATION.
WHEN INFLATING TIRES MAKE SURE THAT:
1) The rim diameter matches the tire diameter.
2) The rim or tire are not defective.
3) The beads are not seated exceeding recommended
pressure.
4) The tire is not inflated beyond the tire manufacturers
instructions.
5) The operator follows proper safety rules.
IMPORTANT SAFETY RULES part n. 4-600990
A) Only trained operators should use this machine.
B) Read and understand the instruction manual before operating this
machine.
C) Wear eye protection.
D) Keep hands and clothing away from moving parts.
E) Service machine regularly as outlined in the instruction manual.
F) Remove all air from tire before loosening beads. Remove valve
core.
G) Remove all wheel weights from rim before mounting or
demounting to prevent damage.
H) Always use a proper bead lubricant before mounting, demounting
and seating beads.
E) Always verify that the tire and the rim are exactly the same bead
diameter. Tire size is molded into the side wall. Rim size is
stamped into the rim. Never mount a tire on a rim if the bead
diameter can not be identified.
F) Inspect the tire and rim carefully for defects. Do not mount the tire
if any defects are found.
G) Seat beads and inflate the tire with short bursts of air while
continuously checking the air pressure.
H) Stand away from the tire and wheel when inflating. Never lean or
reach over the tire during inflation. Keep area clear of by standers.
I) Never exceed the tire manufacturer's recommended maximum air
pressure. Tires can burst when inflated beyond specified limits.
Do not mount any tire unless the tire size
WARNING
(molded in to the side wall) matches the rim
size (stamped into the rim) exactly!
NEVER ATTEMPT TO MOUNT:
16" tires on 16.5" rims
15.5" tires on 16" rims
15" tires on 15.5" rims
15" tires on 390 mm rims
14" tires on 365 mm rims
WARNING
NEVER EXCEED 40 PSI
WHILE SEATING
BEADS.
NEVER EXCEED TIRE
MANUFACTURER
RECOMMENDED
PRESSURE AFTER
SEATING BEADS.
part n. 4-600991
NEVER LEAN OR
REACH OVER TIRE OR
RIM DURING
INFLATION.
WARNING
Bleed air
Keep Keep
pressure
hands legs
from tire
away away
before
from from
breaking
rotating bead
beads.
parts breaker
CAUTION!
RISK OF ELECTRIC SHOCK.
DO NOT OPEN COVER
WARNING
part n. 4-600992
TO REDUCE THE RISK OF ELECTRIC SHOCK DO
NOT EXPOSE THIS TIRE CHANGER TO RAIN.
WATER OR WET LOCATIONS.
WARNING
THIS TIRE CHANGER DOES NOT CONTAIN USER
SERVICEABLE PARTS. DO NOT OPEN COVER. DO
NOT TAMPER WITH COMPONENTS. FAILURE TO
COMPLY MAY CAUSE SERIOUS INJURY OR DEATH
TO OPERATOR OR BYSTANDERS.
14
LABEL, EARTH GROUND TERMI-
NAL
LABEL, DANGER OF INFLATION
LABEL, VARIOUS RISK
LABEL, ELECTRIC RISK
User's manual