COFFEE BREWING
The machine has been specifically designed to use "Metodo Iper-
espresso" illy capsules.
Before brewing coff ee, check that the "
light is steady one and that the water tank is full.
Do not put your fi ngers or any other object in the com-
partment. Single-dose capsules brew a single coff ee.
DO NOT use capsules more than once. When the brewing phase
starts, the machine performs a prebrewing cycle. During this
cycle, coff ee cannot be brewed.
When starting the machine, brew once without
capsule to optimize the system.
• Place 1 cup under the dispensing spout.
• Lift the capsule compartment opening lever.
• Insert the capsule as shown in the fi gure.
• Lower the lever to close the capsule compartment.
If the compartment closing operation proves to be
diffi cult, check that the capsule is correctly inserted
and that the used capsule drawer is not full.
GXI/01
• Press the "
• Coff ee brewing begins. Once the desired
quantity of coff ee has been reached, stop
brewing by pressing "
GXI/02
• Press the "
• Coff ee brewing stops automatically when
the pre-programmed level is reached; how-
ever, it is possible to interrupt coff ee brew-
ing by pressing the "
• 17 •
Adjusting the Brewed Coff ee (GXI/02)
The machine allows you to adjust the amount of brewed coff ee ac-
cording to your taste and the size of your cups.
" button
desired level.
At this point the button "
leased, the machine will brew the same amount of coff ee that was
just programmed.
Drip Tray Height
The drip tray height can be adjusted to adapt to the cups to be
used.
Figure 1 shows how the drip tray has been adjusted to the best
height for tall cups.
" button.
" once again.
For espresso cups, the best height is shown in fi gure 3.
To change the height of the drip tray, remove it from its seat by pull-
" button.
ing it outwards (fi g. 2). Place it on the support guides and push it to
its limit stop (fi g. 3).
" button.
Each time "
" is pressed, the machine is
set to brew a coff ee of approximately 30 cc.
This amount may be reprogrammed to your
taste.
Proceed as follows to reprogram this quan-
tity:
• Place a cup under the dispensing spout.
• Press and hold the "
• Release the "
amount of coffee in the cup reaches the
" is programmed; each time it is re-
Fig.2
Fig.1
" button.
" button when the
Fig.3