Fontanot genius_ra 010 Instructions De Montage page 12

Assembly of wall fixings and accessories
36. Insert the 031075 components in the treads and the BF2 / 031065 elements in the lower part of the
127010 / 127002 balusters so that they correspond with the corner treads and, in the upper part, with the
127012 / 127002 lateral spacers (fig. 1) (fig. 2) (fig. 8) (fig. 9).
37. Fit the closing elements for the 031062 supports; for the base support, cut in height before fitting (fig. 1) (fig. 2).
38. Firmly secure the staircase at the following points:
a) Insert the telescopic post 047087-047085 in an intermediate position (6th-7th riser) on the floor with
parts 047089 and 031070; cut in height if necessary; the 047087 base and 047085 terminal must be the
same length; consider at least 25 cm for insertion of 047085 terminal in 047087 base. Drill the support with
a 13 mm bit and fix the 047089 support bracket with parts 011062, 009047 and 005044. Use a 9 mm bit
for parts 047085 and 047087 and assemble the blocking component with items 046046 and 004052.
b) Fix the staircase to the wall using the 047087, 047085 telescopic post with parts 046029 and 006001;
drill the wall with an 18 mm bit and enlarge the hole entrance to a diameter of 19 mm and a depth of 15 mm
to hold the 006001 tightening nut. Fit parts 006001 onto stays 046029 without reaching the ends; fix to the
wall with chemical resin, wait until dry, and definitively tighten parts 006001. Drill the support with a 13 mm
bit and fix the 047089 support bracket with parts 011062, 009008 and 005009.
12 - Genius 010 - 020 RA