Troubleshooting Guide - Spektrum AR6410LBL Guide De L'utilisateur

EN

Troubleshooting Guide

Problem
Aircraft will not respond
to throttle but responds to
other controls
Extra propeller noise or
extra vibration
Reduced flight time or
aircraft underpowered
LED on receiver flashes
and aircraft will not bind
to transmitter (during
binding)
Possible Cause
Throttle stick and/or throttle
trim too high
Throttle channel is reversed
Motor disconnected from
receiver
Damaged propeller,
spinner or motor
Prop screw is too loose
Flight battery charge is low
Propeller installed backwards
Flight battery damaged
Flight conditions may be
too cold
Battery capacity too low for
flight conditions
Transmitter too near aircraft
during binding process
Bind switch or button not
held long enough during
bind process
14
Solution
Reset controls with throttle
stick and throttle trim at
lowest setting
Reverse throttle channel
on transmitter
Open fuselage and make
sure motor is connected to
the receiver
Replace damaged parts
Tighten the prop screw
Completely recharge flight
battery
Install propeller with
numbers facing forward
Replace flight battery
and follow flight battery
instructions
Make sure battery is warm
before use
Replace battery or use a
larger capacity battery
Power off transmit-
ter, move transmitter
a larger distance from
aircraft, disconnect and
reconnect flight battery to
aircraft and follow binding
instructions
Power off transmitter and
repeat bind process. Hold
transmitter bind button
or switch until receiver
is bound