Spektrum AR6410LBL Guide De L'utilisateur page 12

EN
To Change CH5 to X-port or X-port to CH5
When X-Port is active, CH5 and CH6 are not available; however, reversed aileron
(CH2) is still available.
1. Ensure the receiver and transmitter are bound.
2. Connect the X-Port accessory or optional servo into the X-Port/CH5.
3. Turn the transmitter on.
4. Move the THRO stick to the full throttle position.
5. Move the control sticks to the corresponding position to change between the
available options (see illustration).
6. While holding this position, connect the battery into the receiver; power on the
receiver.
7. The LED on the receiver will turn solid and within 5 seconds, the LED will flash
3 times quickly, indicating the option is now changed.
8. Disconnect the battery from the receiver.
9. Turn the transmitter off.
Mode 2
THRO/RUDD ELEV/AILE
Optional Support Items
Please see www.horizonhobby.com for a complete list of items.
Progrmamming the Brushless ESC
To access a programmable feature, power on with full throttle (musical confirma-
tion sound).
• Pull throttle to center (1 long beep)
To assign No Brake: Push throttle to full (1 short beep). (Default)
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
To assign Soft Brake: Keep throttle at full for 5 seconds (2 short beeps).
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
To assign Center Brake: Keep throttle at full for 10 seconds (3 short beeps).
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
To assign Hard Brake: Keep throttle at full for 15 seconds (4 short beeps).
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
CH5/X-Port
1. Full THRO
2. Right RUDD
12
Mode 1
ELEV/RUDD THRO/AILE