Troubleshooting Guide - Spektrum AR8020T Guide De L'utilisateur

EN

Troubleshooting Guide

Problem
Aircraft
will not
respond to
throttle but
responds
to other
controls
Aircraft will
not Bind
(during
binding) to
transmitter
12
Possible Cause
Throttle not at idle and/or
throttle trim too high
Throttle servo travel is lower
than 100%
Throttle channel is reversed
Motor disconnected from
ESC
Transmitter too near aircraft
during binding process
Aircraft or transmitter is too
close to large metal
object, wireless source or
another transmitter
The bind plug is not in-
stalled correctly in the bind
port
Flight battery/transmitter
battery charge is too low
Bind button not held long
enough during bind process
Solution
Reset controls with throttle
stick and throttle trim at low-
est setting
Make sure throttle servo travel
is 100% or greater
(With battery disconnected
from aircraft) Reverse throttle
channel on transmitter
Make sure motor is connected
to the ESC
Move powered transmitter a
few feet from aircraft, discon-
nect and reconnect flight bat-
tery to aircraft
Move aircraft and transmitter
to another location and at-
tempt binding again
Install bind plug in bind port
and bind the aircraft to the
transmitter
Replace/recharge batteries
Power off and repeat bind
process.