Spektrum AR6410LBL Guide De L'utilisateur page 9

5. If you entered bind mode correctly, you will see a solid LED within about 10
seconds. You should now be bound to the transmitter and have full control and
function.
Transmitter Specific Binding Instructions
1. To bind the AR6400LBL to the transmitter, plug the battery into the receiver. The
LED on the receiver will begin flashing.
2. Move the sticks and switches on the transmitter to the desired failsafe positions
(low throttle and neutral control positions).
3. DX5e: Pull and hold the Trainer Switch on the transmitter while turning the
transmitter on. Release the trainer switch once the LEDs on the front of the
transmitter flash.
DX6i: Pull and hold the Trainer Switch on the transmitter while turning the
transmitter on. Release the trainer switch once the word BIND flashes on the
LCD screen on the front of the transmitter.
DX7s/DX8: Press the bind button on the back of the transmitter while turning the
transmitter on. The bind button on the back of the transmitter will flash.Release
the button after 2–3 seconds.
4. The LED on the receiver will go solid and the system will connect after several
seconds.
IMPORTANT: Once the system is bound, ALWAYS turn the transmitter on first
and then the receiver to prevent the receiver from re-entering bind mode. If your
receiver inadvertently enters bind mode, unplug the battery from the receiver and
reinstall with the transmitter remaining on.
Advanced Programming Features
NOTICE: To make these changes, enlist the use of a helper to either hold the
aircraft to prevent unintended flyaways or to make the changes on the transmitter.
CAUTION: Make sure your receiver is off BEFORE making any advanced
programming changes to prevent the motor from arming.
The following programming features are only recommended for advanced radio
users. The photos in this section show the E-flite MLP4DSM transmitter; however,
the procedures apply to all compatible transmitters. Prior to making any advanced
programming feature changes, it is necessary to:
1. Choose an empty model location .
2. Select model type ACRO.
3. Perform a model reset.
4. Set all channels to normal.
5. Ensure transmitter and receiver are bound.
LED
9
EN