Spektrum AR6410LBL Guide De L'utilisateur page 15

Problem
LED on receiver flashes
rapidly and aircraft will
not respond to transmitter
(after binding)
Control surface does not
move
Controls reversed
Motor loses power
Motor power quickly
decreases and increases
then motor loses power
Motor/ESC is not armed
after landing
Servo locks or freezes at
full travel
Possible Cause
Less than a 5-second wait
between first powering on
transmitter and connecting
flight battery to aircraft
Aircraft bound to different
model memory
(ModelMatch radios only)
TM
Flight battery/transmitter
battery charge is too low
Control surface, control horn,
linkage or servo damage
Wire damaged or
connections loose
Flight battery charge is low
Control linkage does not
move freely
Transmitter settings reversed
Damage to motor or power
components
Battery power is down to the
point of receiver/ESC Low
Voltage Cutoff (LVC)
Over Current Protection
(OCP) stops the motor when
the transmitter throttle is
set high and the propeller
cannot turn
Travel adjust value is set
above 100% overdriving
the servo
15
Solution
Leave transmitter on,
disconnect and reconnect
flight battery to aircraft
Select correct model
memory on transmitter and
disconnect and reconnect
flight battery to aircraft
Replace/recharge batteries
Replace or repair damaged
parts and adjust controls
Check wires and
connections, connect or
replace as needed
Fully recharge flight
battery
Make sure control linkage
moves freely
Perform Control Direction
Test and adjust controls
on transmitter appro-
priately
Check motor and power
components for damage
(replace as needed)
Recharge flight battery or
replace battery that is no
longer performing
Fully lower throttle and
throttle trim to arm ESC
Set Travel adjust to 100%
or less and/or set sub-
trims to Zero and adjust
linkages mechanically.
EN