Spektrum AR6410LBL Guide De L'utilisateur page 10

EN
CAUTION: Secure the aircraft safely to a work bench or enlist the use of a
helper while accessing the advanced programming features. Mistakes in
programming could cause the motor to run unexpectedly.
Reversing Servos
Servo reversing is done through your transmitter' s servo reversing function.
You may also reverse the actual servos by following the instructions below.
Reversing The Servos on the Receiver Board
This feature reverses the servos at the board level, making it useful for implemen-
ting features, such as elevons, while using transmitters with limited programming
options.
NOTICE: For all advanced programming changes, you must hold the control
sticks in the correct position with the transmitter on and the receiver off.
1. Ensure a successful bind was completed.
2. Turn the transmitter on.
3. Move the THRO stick to full throttle position.
4. Move the control sticks to the corresponding position for the servo to be
reversed (see illustration).
5. While holding this position, connect the battery to the receiver; power on th e
receiver.
6. The LED on the receiver will turn solid and within 5 seconds, the LED will flash
3 times quickly, indicating servo is now reversed.
7. Disconnect the battery from the receiver.
8. Turn the transmitter off.
Mode 1
THRO/RUDD ELEV/AILE
THRO/RUDD ELEV/AILE
THRO/RUDD ELEV/AILE
CH2
1. Full THRO
2. Down ELEV
3. Left AILE
CH3
1. Full THRO
2. Down ELEV
3. Right AILE
CH4
1. Full THRO
2. Up ELEV
3. Right AILE
10
Mode 2
ELEV/RUDD THRO/AILE
ELEV/RUDD THRO/AILE
ELEV/RUDD THRO/AILE