Spektrum AR6410LBL Guide De L'utilisateur page 8

EN
Servos
The AR6410LBL incorporates integrated servos; optional specially designed
servos are available through Spektrum.
NOTICE: Using any servo(s) other than those designed for use with the AR6410L-
BL may cause damage to the receiver and/or servo(s) and will void the warranty.
Installing and Plugging in the Optional Servos
Use double-sided foam tape strips and/or minimal hot glue to mount the servos in
place. The servos must be in the appropriate position to attach to the corre-
sponding pushrods. Plug the servo leads into the appropriate servo ports in the
receiver, noting the polarity of the servo connector. Installation will vary depending
on the application.
Smart Bind
™
You must first bind the receiver to the transmitter for it to operate. Binding is
teaching the receiver the specific code of the transmitter so it only connects to
that transmitter. The AR6410LBL features Smart Bind. When the receiver is first
powered, the receiver looks for the signal of its previously bound transmitter for
5 seconds. If no signal is found, the receiver automatically goes into bind mode,
indicated by the flashing LED.
Binding
1. Make sure the flight battery is fully charged.
2. Confirm the flight battery is disconnected from the receiver/ESC unit and the
transmitter is turned off.
3. Plug the flight battery into the receiver' s battery connector. After 5 seconds, the
LED on the receiver begins to flash.
4. After verifying the LED is flashing on the receiver, bind the receiver to the
transmitter (see your transmitter' s manual or the supplement that follows).
Optional Linear Servo
8