LaserLiner SensoMaster 400 Mode D'emploi page 25

PRIMARY SWITCH FUNCTIONS
2. Units of Measure Switch:
Press once to display the current settings in the numeric display area. Press again
while the units are displayed (within one second) to change the current selection.
Subsequent presses will scroll through the setting selections of centimeters (cm),
millimeters (mm), inches (in), fractional inches (in), and feet (ft). For fractional inches,
the fraction bar will be displayed on the LCD. The selected setting will always be
displayed on the top of the LCD.
3. Volume Switch:
Pressing the switch cycles High, Medium, Low and Off. One beep is emitted at the
selected volume when changed. When sound if Off, a single beep will signal that a
laser beam has been detected.
4. Accuracy Switch:
Press once to numerically display current accuracy settings on the LCD. Press again
while the accuracy is displayed (within one second) to change the current selection.
Subsequent presses will scroll through five accuracy options (Ultra Fine, Super Fine,
Fine, Medium, Coarse).
SensoMaster 400
ENGLISH ENGLISH
Deutsch
25
1