Troubleshooting; Disposal - Mobicool S13 DC Notice D'emploi

_S13_S24_S28_S32.book Seite 9 Mittwoch, 7. Mai 2008 2:07 14
S13, S24, S28, S32
7

Troubleshooting

Fault
Your cooler does not
function (plug is
inserted).
Your cooler does not
cool (plug is inserted).
Operation with a 12 V
socket (cigarette
lighter):
The ignition is on and
the cooler is not work-
ing.
Pull the plug out of
the socket and make
the following checks.
8

Disposal

➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
If you wish to finally dispose of the device, ask your local recycling
centre or specialist dealer for details about how to do this in accord-
ance with the applicable disposal regulations.
Possible cause
There is no voltage flowing
from the 12 V socket (ciga-
rette lighter) in your vehicle.
No voltage present at the
AC voltage socket
(
S28 DC/AC, S32 DC/AC
)
only .
The inner fan or the cooling
element is defective.
The cigarette lighter socket
is dirty. This results in a
poor electrical contact.
The fuse of the 12 V plug
has blown.
The vehicle fuse has
blown.
Troubleshooting
Suggested remedy
The ignition must be switched on in
most vehicles for voltage to flow at the
cigarette lighter.
Try using another plug socket.
This can only be repaired by an author-
ised customer services unit.
If the plug of your cooler becomes very
warm in the cigarette lighter socket,
either the socket must be cleaned or the
plug has not been assembled correctly.
Replace the fuse (5 A) in the 12 V plug
(fig. 3 1, page 3).
Replace the vehicle's 12 V socket fuse
(usually 15 A). (Please refer to the oper-
ating manual of your vehicle.)
9