Wiring Plan, Single Chamber Housing - Balluff BMD 1L K Série Notice D'utilisation

5 Connecting to power supply
24
Fig. 12: Connection steps 5 and 6 - Single chamber housing
6. Insert the wire ends into the terminals according to the wiring plan
Information:
end sleeves, press the terminal from above with a small screwdriver,
the terminal opening is then free. When the screwdriver is released,
the terminal closes again.
"Technical data - Electromechanical data".
7. Check the hold of the wires in the terminals by lightly pulling on
them
external ground terminal to potential equalisation
9. Tighten the compression nut of the cable entry gland. The seal
ring must completely encircle the cable
10. Reinsert the display and adjustment module, if one was installed
11. Screw the housing lid back on
5.3

Wiring plan, single chamber housing

The following illustration applies to the non-Ex, Ex-ia and Ex-d-ia
version.
-