EUROM RAD 2200 Manuel D'utilisation page 19

 Screw the 2 x 2 swivel castors with the 4 capped nuts onto the ends of the two wheel
supports. The wheels should be at the hollow side!
 Turn the radiator upside-down (make sure you don't scratch the paint or the floor!)
 Remove the wing nuts from the U-shaped bolts.
 Then mount the U-shaped bolts left and right between the outer fins.
 Slide the wheel supports with wheels over the ends of the U-shaped bolt, so that the
wheels are eventually mounted as illustrated on the front of this booklet: i.e. as far apart
as possible.
 Now tighten the wing nuts tightly onto the ends of the U-shaped bolt, but not so tight as
to damage the oil-filled fins.
 Return the heater to its upright position, wheels down.
Warning: only use the heater when it is in an upright position, with the wheels
attached to the bottom (as pictured on the front of this booklet).
 Choose a suitable location for the heater which is at least one meter away from any
obstructions, walls or inflammable materials (see also safety instructions).
 Make sure a functioning heater is always placed on a solid, flat and horizontal surface.
Never place it on a bed, couch, deep pile carpet etcetera!
 Check that the socket used is grounded and that it matches the power specified on the
heater's type plate.
Set-up and Operation
 Set the Power switch to 0 (off) and the thermostat button to on maximum right
 Fully insert the plug into the grounded socket. When doing so, completely unwind the
electrical cable.
 Operate the heater by setting the power switch to I, II or III. The heater will now operate
at 1000 W (light on left lights up), 1200W (light on right lights up) or 2200W (both lights
light up).
Thermostat:
Once the space has reached the right temperature, turn the thermostat dial to MIN until you
hear a click. If you leave the dial in this position, the heater will maintain the current
temperature by regularly switching on and off. By turning the thermostat dial to the right / left
you increase/decrease the set temperature. If so desired, you can now switch to a lower
power level.
Any other position is dangerous!
19