Checking For Blockages - shark Navigator Pet ZU60 Série Guide De L'utilisateur

MAINTENANCE
Self-Cleaning Brushroll
Shark's self-cleaning brushroll automatically removes hair wrap. If some hair remains
wrapped around the brushroll, continue cleaning to give it time to make its way to the
dust cup.
If you run over a hard or sharp object or notice a noise change while vacuuming, check
for blockages or objects caught behind the brushroll.
BRUSHROLL ACCESS
Using a coin, turn locks counterclockwise, then lift the door to access Brushroll.
DEBRIS WRAPPED AROUND BRUSHROLL
Clean off any debris on the bristles.
NOTE: If any hair is wrapped around the brushroll, extending
cleaning time will allow the self-cleaning brushroll remove it
for you. If some fibers remain wrapped around brushroll after
continued use, carefully cut debris with scissors and remove
from brushroll.
s h a r kc l e a n . c o m
DEBRIS BEHIND BRUSHROLL
Clear away any dust, dirt, or blockages in
Debris Intake.
To close the cover, push down until it clicks into
place, then close the locks with a coin.

CHECKING FOR BLOCKAGES

Detach hose from vacuum pod, and check hose
and opening on back of pod for blockages.
Detach the wand from the pod, place the pod on
its side, and check opening for blockages.
Detach dust cup from vacuum pod. Empty dust
cup, remove debris from lint screen, and check for
blockages.
Detach wand from floor nozzle and handle, and
check both ends for blockages.
Detach the handle from the wand and the hose
from the vacuum pod, and check openings for
blockages.
s h a r kc l e a n . c o m