Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WHOLE-HOME CLEANING
POWER/SURFACE SWITCH
Select surface setting:
O Power Off
I Hard Floor
For bare floors and small area rugs,
the brushroll will spin slowly.
II Carpet
For carpets, the brushroll will spin
quickly to pick up stuck on debris.
BRUSHROLL INDICATOR LIGHT
INDICATOR LIGHT
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning and working as it should.
Solid Red: There is a jam in the brushroll area. Turn your vacuum off, unplug from the wall and
remove any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn your vacuum off and wait a
minimum of 45 minutes for it to cool down.
NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets), set to MAX suction and use setting II, Carpet.
s h a r kc l e a n . c o m
SETTINGS
SUCTION CONTROL
The Suction Control slider located on the handle
allows you to adjust the suction depending on the
floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on bare floors.
WHOLE-HOME CLEANING
CLEANING MODES
UPRIGHT
To engage brushroll, step on floor nozzle
and tilt handle back.
Handle
ABOVE-FLOOR—HANDLE
Press the Handle Release button to detach
the handle from the wand.
NOTE: All accessories are compatible with both the wand and the handle.
ABOVE-FLOOR—WAND
Press the Wand Release button to detach the
wand from the pod.
s h a r kc l e a n . c o m
Publicité
Table des Matières
