EUROM Outdoor Heatpanel Mode D'emploi page 14

14
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating duet or
wind could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220/240V-50Hz).
If everything is all right you can switch on or insert the plug into the socket. The Outdoor
Heatpanel will start to work. Once the unit is turned on, it will take approximately 15
minutes to warm up to normal operating temperature.
When you use the appliance for the first time (or after a long time again), observe it
during the first 20 till 30 minutes to be sure that is works trouble-free. During initial use
and if the unit is not used for a long period, white smoke may be emitted from the panel.
This is normal and will stop after a few minutes. During the warm-up period, the unit may
sputter; this is nothing to worry about.
To stop the Outdoor Heatpanel, switch off or take the plug out of the socket. Give the
Outdoor Heatpanel time to cool down.
CLEANING - MAINTENANCE - SERVICE
It is important to clean the device regularly particularly if it hangs Outdoors. Cleaning
extends the life-span of the device and ensures it works effectively. It is also a condition
of the guarantee.
Clean the device every 2-3 weeks (depending on the environment); clean weekly in a
salty environment. Salt in the air can penetrate the device and rust or erode the metal
but air pollution in an urban setting can also penetrate the coatings and other materials
that protect the Outdoor Heatpanel against rust and erosion.
You must thoroughly clean and inspect the device once every 3 months.
Be aware that, despite regular cleaning, the weather, air pollution and any salt, cigarette
smoke, oil lamps, candles, barbecues etc will leave their mark on the device over time.
Attention! Before cleaning, always switch off / remove the plug from the socket and
allow the lamp to cool down (1 hour).
The fact that the device is protected by IPX4 means that it can safely be cleaned with
(warm) water. Do not use a pressure sprayer or similar; only use a wet cloth. If you use a
mild cleaning agent, make sure that all of the residues are removed properly!
Dust the device with a clean, soft, lint-free cloth or soft brush. Do not use aggressive
cleaning agents, scouring sponges, brushes or chemical cleaners as this could damage the
materials. Never use flammable cleaning products such as benzene or methylated spirit.
Keep the cable and plug dry.
Do not forget to clean the back of the Outdoor Heatpanel; insects, bird faeces, dust, salt
and other dirt may gather here!
After cleaning, put the heater on for 20 minutes in order to dry out.
Check the Outdoor Heatpanel regularly and always do so after high winds or unusual
events that may impact upon the heating panel.
Inside the EUROM OUTDOOR HEATPANEL are no user serviceable parts. Repairs must be
carried out by authorised specialists (dealer or electrician), thus ensuring electrical safety.
The warranty does not cover damage or failure which are the result of self-made
reparations or alterations, accident, misuse, abuse, neglect, commercial use or improper
maintenance.