Cleaning The Brewing Unit - Siemens TE501 Série Mode D'emploi

en
8. Attach the milk frother to the steam
valve. Check that the red mark on the
steam valve is covered.
¡ ¡
Risk of scalding!
Only use the appliance when the milk froth-
er (6) is completely assembled and fitted.

Cleaning the brewing unit

Clean the brewing unit regularly.
To pre-clean the brewing unit automatically:
Press the service button (12) briefly. The
appliance will rinse if coffee was dispensed
previously. It then switches off.
In addition to the automatic cleaning pro-
gramme, the brewing unit (5a) should be
removed regularly for cleaning (Figure E at
the beginning of the instructions).
1. Press the power on/off switch O / I (9) to
switch off the appliance. All lights go off.
2. Open the door (5b) to the brewing unit.
3. Slide the red lock (5d) on the brewing
unit completely to the left.
4. Press the red pushbutton (5c), grasp the
brewing unit by the recessed grips and
withdraw it from the appliance.
16
5. Rinse the brewing unit (5a) thoroughly
under running water.
6. Hold the brewing unit sieve under the
running water.
Important: Do not clean with detergent or
other cleaning agents and do not put it in
the dishwasher.
7. Wipe out the inside of the appliance
thoroughly with a damp cloth and
remove any coffee residues.
8. Allow the brewing unit (5a) and the
interior of the appliance to dry.
9. Reinsert the brewing unit (5a) fully into
the appliance.
10. Slide the red lock (5d) fully to the right
and close the door (5b).