Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
en Daily care and cleaning
Cleaning the drip tray and
coffee grounds container
~ Fig. %
Note:
The drip tray and coffee grounds
container should be emptied and
cleaned every day in order to prevent
deposits.With frequent use also empty
from time to time, as soon as the float is
clearly visible, or the relevant message
appears in the display.
1.
Open the door.
Pull the drip tray with the coffee
2.
grounds container forwards and out.
Remove the drip plate with grate.
3.
Empty and clean the drip tray and
4.
coffee grounds container.
Wipe out the inside of the appliance
5.
(area of drip tray).
Cleaning the milk system
C lean the milk system after each use to
C l e a n i n g t h e m i l k s y s t e m
remove residues and ensure the
function.
:
Warning
Risk of burns!
The milk frother gets very hot. Hold only
by the handle. After use, let it cool down
first before touching it.
Fill a glass half-full with water and
1.
place under the outlet system.
Push the milk frother right down.
2.
Touch the milk button to clean the
3.
milk system.
Push the milk frother right up and
4.
allow it to cool down.
Dismantle the milk frother into its
5.
individual parts and clean
thoroughly.
~ Fig. &
6.
Dry the individual parts, reassemble
and fit back onto the appliance.
46
Notes
To stop the process before the end,
■
touch milk again.
All parts of the milk system should
■
be cleaned in the dishwasher.
Detergent residues in the milk
system must be thoroughly removed
following the rinsing process.
Cleaning the brewing unit
~ Fig. $, ~ Fig. %
In addition to automatic cleaning, the
brewing unit should be removed
regularly for cleaning.
Caution!
Clean the brewing unit without detergent
or products containing vinegar or acid
and do not place in the dishwasher.
Remove the brewing unit:
1.
Switch off the appliance.
Open the door to the brewing
2.
chamber.
Remove the coffee grounds
3.
container.
4.
Push the red lever up, grasp the
brewing unit by the handle and pull
forwards carefully.
5.
Rinse the brewing unit thoroughly
under warm, running water.
Clean the interior of the appliance
6.
thoroughly with a damp cloth,
removing any coffee residues.
7.
Allow the brewing unit and the
interior of the appliance to dry.
Insert the brewing unit:
Hold the brewing unit only by the
1.
handle.
2.
Push the red lever up, position the
brewing unit underneath and slide
back as far as it will go. The lever
must snap into place.
Insert the coffee grounds container
3.
again and close the door.
Important: If the brewing unit has not
been inserted, or the brewing unit or
drip tray not inserted correctly, it will not
be possible to close the door.
Publicité
Chapitres
Table des Matières
