Coffee Strength" Rotary Knob; Drink Selection" Rotary Knob; Milk Frother; Before Using For The First Time - Siemens TE501 Série Mode D'emploi

"Coffee strength" rotary knob

This rotary knob (13) is used
to adjust the coffee strength
or select the setting for pre-
ground coffee.
h
Very mild
Mild
to
Medium
g
Strong
G
Ground coffee

"Drink selection" rotary knob

This rotary knob (14) is
used to select the required
beverage and quantity. It is
also used to change user
settings.
a
Small espresso
Espresso
to
Small café crème
Café crème
c
Large café crème
b
2 small espresso
2 espresso
to 2 small café crèmes
2 café crèmes
d
2 large café crèmes

Milk frother

Pull the milk frother (6a) out to open it and
push it back in to close it.
Before using for
the first time
General
Fill the water tank with fresh, uncarbonated
water only and preferably use only beans
or coffee blends suitable for fully automatic
espresso and coffee machines. Do not
use coffee beans that have been glazed,
caramelised or treated with other additives
containing sugar, since they will block the
brewing unit.
The water hardness setting can be adjusted
on this appliance. The factory setting for the
water hardness is 4. Check the hardness
of the water you use with the enclosed test
strip. If the test reveals a value other than 4,
change the setting on the appliance ac-
cordingly after switching on (see "Settings",
"Water hardness" on page 11).
Setting up the appliance
1. Remove the protective film.
2. Place the fully automatic espresso ma-
chine on a flat, water-resistant surface
that can take its weight. The ventila-
tion slots on the appliance must not be
covered.
Important: Only use the appliance in
frost-free rooms. If the appliance has been
transported or stored at temperatures below
0 °C, wait at least 3 hours before operation.
3. Pull out the mains plug from the cable
compartment (20) and plug it in. Adjust
the length of the cable by pushing it
back in and pulling it out. To do this,
place the appliance with its back flush
with the edge of the work surface and
either pull the cable downwards or
push it upwards.
en
9