Technical Services - Hamilton Beach Commercial SmartServe Manuel D'utilisation

This equipment is intended for professional use and should be used by trained and qualified personnel
only.
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Cut Hazard
Do not put hands, spoons, or other
utensils in container when blending.
Failure to follow these instructions can
result in broken bones, cuts, or other
injuries.
Burn Hazard
Always use caution when blending
hot contents.
Failure to follow these instructions can
result in burns.
The EC declaration of conformity for this equipment is available in the Technical Support
section of our website www.hamiltonbeachcommercial.com.
Recycling the Product at the End of Its Service Life
The wheeled bin symbol marked on this drink mixer signifies that this equipment should be taken
over by a selective collection system conforming to the Guideline 2002/96/EC (WEEE) so that it
can be either recycled or dismantled in order to reduce any impact to the environment. The user is
responsible for returning the product to the appropriate collection facility, as specified by your local
code. For additional information regarding applicable local laws, please contact the municipal facility
and/or local distributor.
840225900 v12.indd 3
WARNING
Electrical Shock Hazard
Disconnect power before
cleaning.
Failure to follow these
instructions can result in
death or electrical shock.
WARNING
WARNING
WARNING
FOR COMMERCIAL USE ONLY

Technical Services

For assistance or replacement parts, call our
Technical Services number:
+ 1-910-693-4277
www.hamiltonbeachcommercial.com
Sanitizing
Sanitize using 15 ml (1 tablespoon) of household
bleach per 3.8 liter (1 gallon) of clean, cool water
(60°F/16°C), mixed according to the instructions
on the bleach.
1. Turn ON (I) by pressing the power switch (3)
under the control panel (2) on the right side.
2. Run a flush cycle.
For MIC Only:
• Remove thumbscrews (6).
3. Run any preprogrammed cycle (using the 1–3
and A–C buttons). DO NOT OPEN DOOR (5)!
For MIC Only:
• At end of cycle when cup shield (14) moves
upward, slide the door assembly (9) toward
you slightly to pause the cycle.
• Use sanitizing syringe (17) to inject 60 ml of
sanitizing solution into the sanitizing port (11).
Remove sanitizing syringe (17) and set aside.
• Wait 2 minutes or appropriate sanitizing time.
• Replace door assembly (9) and thumbscrews
(6).
Cycle will now finish and return cup shield (14)
to the highest position.
4. After appropriate sanitizer time, remove cup and
pour contents down the drain (10).
5. Allow the equipment to rinse.
For MIC Only:
• Press the RINSE button (2b).
3
4/22/15 3:48 PM