12.11. MANUAL FUNCTIONS
The intelligent controller has, in addition to the programmable automated features for activating the pump and the
swimming pool lights, two manual functions that enable manual start of the pump as well as manual activation of
the swimming pool lights.
To manually activate the pump, from the stand-by screen select the pump timer activation submenu by pressing
In this screen, each time
30 minutes, 60 minutes, 2 hours, 4 hours, 8 hours or deactivation. Just select the manual time desired and after a
few seconds the pump will be activated for the set time. The pump will deactivate once the intelligent controller has
checked that the selected time has transpired.
Note: It must be pointed out that if a filtration cycle begins during manual timing of the pump, or the external
intake enables the pump for operation, the pump will not stop until the end of the manually selected time, as long as
the programme filtration is not finalised, or the external intake disables operation of the pump, respectively. It also
indicates that if the chlorinator outlet is enabled with operation of the pump, this outlet will also be activated during
manual operation.
To manually activate the swimming pool lights, there is a specific button
The same as for manual activation of the pump, each press enables manual operating time of the lights to be selected:
In this case, the times that can be selected are 15 minutes, 30 minutes, 60 minutes, 2 hours, 4 hours, 8 hours or
deactivation. Only the manual operating time must be selected and after a few seconds the lights will activate for the
manually set time.
Note: It must be pointed out that if a lighting cycle starts during the manual timing of the lights, the pump will not
stop until the end of the manually selected time, as long as the automatic lighting time has not finalised.
B
O
M
B
A
-
>
is pressed, the manual activation of the pump can be selected for 2 minutes, 5 minutes,
F1
L
I
G
H
T S
=
6
0
m
i
n
=
1
5
m
i
n
27
ENGLISH
.
:
F1