Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions – Surface Strip Retrofit Kit (SSRK)
7 .
Additional wire management clips are provided in
hardware bag and can be installed as needed.
8.
The mounting brackets have tape on each end to help
assist with installation. Before installation, clean the
sides of the existing fixture to remove any oil, dirt or
grease. Then remove the protective cover over the tape
by pulling on the tab. The tape will ONLY TEMPORALLY
hold the gear tray in place and is NOT designed to hold
the gear tray in place permanently. (Figure 4.)
Gear Tray
Tape
Mounting Bracket
Figure 4.
4
COOPER LIGHTING SOLUTIONS
IB519100EN
Installation instructions
9.
To install, place the gear tray over existing fixture,
making sure the gear tray sits tight against the existing
channel and all of the wires are inside of the existing
fixture channel. Then FIRMLY press the mounting
brackets against the channel to seat the tape properly.
10. Fasten the mounting brackets to the sides of the
existing channel using the TEK screws. Install 1 TEK
screw on each side of the mounting brackets, for a total
of 4 different places. (Figure 5.)
TEK Screw
Figure 5.
11. Install lens as applicable.
12. Turn breaker on and energize the fixture to verify light
turns on.
Publicité
