Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

IB519118EN
Installation Instructions – CGTSURF24
Instructions d'installation – CGTSURF24
Instrucciones de instalación – CGTSURF24
Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this product
must be performed by a qualified electrician. This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of the product and hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting any
maintenance. Disconnect power at fuse or circuit breaker.
Risk of Fire- Minimum 90°C supply conductors.
Risk of Burn- Disconnect power and allow fixture to cool before handling or servicing.
Risk of Personal Injury- Due to sharp edges, handle with care.
Failure to comply with these instructions may result in death, serious bodily injury and property damage.
DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind that may
arise from the improper, careless, or negligent installation, handling or use of this product.
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
NOTICE: Green ground screw provided in proper location. Do not relocate.
NOTICE: Fixture may become damaged and/or unstable if not installed properly.
Note: Specifications and dimensions subject to change without notice.
ATTENTION Receiving Department: Note actual fixture description of any shortage or noticeable damage on delivery
receipt. File claim for common carrier (LTL) directly with carrier. Claims for concealed damage must be filed within 15 days
of delivery. All damaged material, complete with original packing must be retained.
WARNING
Metalux

Publicité

loading

Sommaire des Matières pour Cooper Lighting Solutions Metalux CGTSURF24

  • Page 1 Failure to comply with these instructions may result in death, serious bodily injury and property damage. DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind that may arise from the improper, careless, or negligent installation, handling or use of this product.
  • Page 2 A3. Join a short rail with the long rails by inserting the protruding leg of each L- bracket into the corresponding slot on the long rail. Repeat on the opposite side to form a rectangle. (Figure 3.) Figure 5.  COOPER LIGHTING SOLUTIONS IB519118EN Installation instructions...
  • Page 3 A8. Hang the fixture from the 2 tethers by inserting Screws may strip if over torqued. ote: each toggle through a hole on the grid clip tabs on each side of the fixture. (Figure 8.) Floating Long Rail Figure 11.  Figure 8.  COOPER LIGHTING SOLUTIONS IB519118EN Installation instructions...
  • Page 4 Figure 15.  Long Rail With Tether Anchors Must Be Closest To Floor And Secured To Figure 16.  The Wall Figure 13.  B6. Follow steps A9 – A11 above to complete the installation of the fixture. COOPER LIGHTING SOLUTIONS IB519118EN Installation instructions...
  • Page 5 (Figure 18.) Screws may strip if over torqued. ote: Figure 20.  C5. Follow instructions included with suspension kit to complete installation of the fixture. Figure 18.  COOPER LIGHTING SOLUTIONS IB519118EN Installation instructions...
  • Page 6 La désobéissance aux instructions suivantes représente un risque de blessures graves ou mortelles et de dommages matériels. EXONÉRATION DE RESPONSABILITÉ : Cooper Lighting Solutions n’assume aucune responsabilité pour les dommages ou pertes de toute nature pouvant découler d’une installation inappropriée, imprudente ou négligente et d’une mauvaise manipulation ou utilisation de ce produit.
  • Page 7 à l’intérieur du de chaque côté du luminaire. (Figure 8.) boîtier pour l’excédent de conduit métallique flexible. (Figure 5.) Boîte de jonction du conducteur d’alimentation Figure 5.  Figure 8.  COOPER LIGHTING SOLUTIONS IB519118EN Installation instructions...
  • Page 8 Ne serrez pas trop les vis pour éviter d’endommager ote: la tête. Rail long lâche Le rail long sur lequel sont installés les ancrages d’attache doit être le plus près du plancher et doit être fixé au mur Figure 11.  Figure 13.  COOPER LIGHTING SOLUTIONS IB519118EN Installation instructions...
  • Page 9 (Figures 15 et 16.) (Figure 18.) Ne serrez pas trop les vis pour éviter d’endommager ote: la tête. Figure 15.  Figure 18.  Figure 16.  B6. Suivez les étapes A9 à A11 ci-dessus pour terminer l’installation du luminaire. COOPER LIGHTING SOLUTIONS IB519118EN Installation instructions...
  • Page 10 C4. Installez le rail long, les supports en L et les vis qui rainure depuis l’extrémité ouverte. (Figure 19.) restent. (Figure 20.) Ne serrez pas trop les vis pour éviter d’endommager ote: la tête. Figure 19.  Figure 20.  C5. Suivez les instructions fournies avec la trousse de suspension pour terminer l’installation du luminaire. COOPER LIGHTING SOLUTIONS IB519118EN Installation instructions...
  • Page 11 El incumplimiento de estas instrucciones puede ocasionar la muerte, lesiones corporales graves y daños a la propiedad. RENUNCIA DE RESPONSABILIDAD: Cooper Lighting Solutions no asume ninguna responsabilidad por daños o pérdidas de ningún tipo que puedan surgir por la instalación, manipulación o uso inadecuado, descuidado o negligente de este producto.
  • Page 12 Esto asegurará que haya suficiente espacio libre dentro de la caja para un exceso de conducto de metal flexible. (Figura 5.) Caja de conexiones del conductor de suministro Figura 5.  Figura 8.  COOPER LIGHTING SOLUTIONS IB519118EN Installation instructions...
  • Page 13 Los tornillos pueden dañarse si se aprietan ota: demasiado. Riel largo flotante El riel largo con los anclajes de la correa debe estar más cerca del piso y asegurado a la pared Figura 13.  Figura 11.  COOPER LIGHTING SOLUTIONS IB519118EN Installation instructions...
  • Page 14 (Figura 18.) Los tornillos pueden dañarse si se aprietan ota: demasiado. Figura 15.  Figura 18.  Figura 16.  B6. Siga los pasos A9 - A11 antes mencionados para completar la instalación de la luminaria. COOPER LIGHTING SOLUTIONS IB519118EN Installation instructions...
  • Page 15 (Figura 19.) tornillos. (Figura 20.) Los tornillos pueden dañarse si se aprietan ota: demasiado. Figura 19.  Figura 20.  C5. Siga las instrucciones incluidas con el kit de suspensión para completar la instalación de la luminaria. COOPER LIGHTING SOLUTIONS IB519118EN Installation instructions...
  • Page 16 Veuillez consulter le site www.cooperlighting.com pour obtenir les conditions générales. Garantías y Limitación de Responsabilidad Visite www.cooperlighting.com para conocer nuestros términos y condiciones. Cooper Lighting Solutions is a registered trademark. All trademarks are property of their respective owners. Product availability, specifications,...