Replacing The Diaphragm - Burkert 2730 Manuel D'utilisation

Masquer les pouces Voir aussi pour 2730:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

12.2

replacing the diaphragm

required spare part
• Diaphragm
fastening types
Orifice dn
fastening types for diaphragms
(diaphragm
ptfe
size)
65
Diaphragm with bayonet
80
catch
100
Tab. 9:
Fastening types for diaphragms
Danger!
risk of injury from discharge of medium and pressure!
It is dangerous to remove a device which is under pressure due to
the sudden release of pressure or discharge of medium.
▶ Before removing a device, switch off the pressure and vent the
lines.
22
epdm / fkm
Diaphragm screwed in
english
Type 2730 / 2731 DN 65-100
Repairs
replacement for control function a
Clamp the valve body in a holding device
(applies only to valves not yet installed).
notiCe!
damage to the diaphragm or the seat contour!
▶ When removing the actuator, ensure that the valve is in open
position.
Pressurize lower pilot air port of the actuator with compressed
air (5 bar): valve opens.
Loosen the body screws / body nuts.
Remove the actuator from the body.
Unscrew old diaphragm. If attachment is with a bayonet catch,
remove the diaphragm by rotating it through 90°.
Install new diaphragm.
Align diaphragm.
the marker flap of the diaphragm must be perpendicular to
the direction of flow (see "Fig. 14")!
Place actuator back on the body.
Insert the body screws / body nuts and lightly cross-tighten until
the diaphragm is between the body and actuator.
do not tighten the body screws / body nuts yet.
Actuate the diaphragm control valve twice.
Without pressurization tighten the body screws / body nuts
to the permitted tightening torque (see "Tab. 10: Tightening
torques for diaphragms").

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

2731

Table des Matières