Installation Instructions - BORETTI BIKW-40 Notice D'emploi

Installation instructions

The installation comes under the exclusive res-
ponsibility of specialists. The installer is held to
respect the local legislation and standards.
How to fix the gasket:
The gasket supplied with the hob avoids all infil-
tration of liquids in the cabinet.
This installation has to be done carefully, in
conformity of the following drawing.
Fitting - installing:
• The cut out sizes are:
Reference Worktop cut-out (mm)
Width x Depth
BIKW-40 366 x 466
• The piece of furniture or the support in which
the hob is to be fitted, as well as the edges
of furniture, the laminate coatings and the
glue used to fix them, must be able to resist
temperatures of up to 100 °C.
• The mural rods of edge must be heat-resi-
sting.
• The hobs are classified as "Y" class for heat
protection. Ideally the hob should be installed
with plenty of space on either side. There may
be a wall at the rear and tall units or a wall at
one side. On the other side, however, no unit
or divider must stand higher than the hob.
• Ensure that there is a distance of 50 mm
between the hob and the wall or sides.
• Materials which are often used to make
worktops expand on contact with water. To
protect the cut out edge, apply a coat of
varnish or special sealant. Particular care
must be given to applying the adhesive joint
supplied with the hob to prevent any leakage
into the supporting furniture. This gasket
guaranties a correct seal when used in con-
junction with smooth work top surfaces.
2 mm
Stick the gasket (2) two millimetres from the
external edge of the glass, after removing the
protection sheet (3).
• Not to install the hob to the top of a not ven-
tilated oven or a dishwasher.
• To guarantee under the bottom of the hob
casing a space of 20 mm to ensure a good
air circulation of the electronic device.
• To guarantee between the work top and the
top of the drawer or oven a space of 5 mm
to allow the exit of the air flow.
• If a drawer is placed under the work, avoid
to put into this drawer flammable objects
(for example: sprays) or not heat-resistant
objects.
• The safety gap between the hob and the coo-
ker hood placed above must respect the indi-
cations of the hood manufacturer. In case of
absence of instructions respect a distance
minimum of 760 mm.
• The connection cord should be subjected, af-
ter building, with no mechanical constraint,
such for example of the fact of the drawer.
• The installation of the hob in no stationary si-
tes (for example: boat) should be undertaken
by specialists.
NL
FR
D
EN
55