Storage; Possible Faults - ATIKA FC 40-255 Notice Originale

Storage

Before each storage
− Switch off device.
− Wait until the cutting device does not longer
move.
− Remove the battery.
Store machines that are not in use in a dry locked place

protected against frost and outside the reach of children
and unauthorized persons.
Secure the cutting blade (10A) with the transport guard

(10B).
Do not rest the device on the guard when storing it to avoid

deformation of the guard.
Best store the device suspended. An opening (M) for

hanging it up is provided in the housing.
Before each fault elimination:
− Switch off device.
− Wait until the cutting device does not longer move.
− Remove the battery.
− Wear protective gloves.

After each fault clearance, put into operation and recheck all security installations.
Fault code
Machine does not start after
switching on
Machine does not work with full
performance
Machine does not cut properly
Machine cuts with interruptions
Device shuts off on its own
Device does not run quietly,
vibrates strongly

Possible faults

Possible Cause
 Lithium ion battery run down
 Lithium-ion battery not engaged correctly
 Lithium ion battery defective
 ON/OFF-switch on operating handle
defective
 Drive unit defective
 Internal fault
 Lithium ion battery run down
 Lithium ion battery defective
 Cutting blade dull or damaged
 Cutting thread damaged or too short
 ON/OFF-switch on operating handle
defective
 Internal fault
 Lithium ion batteries too hot (45 °C)
 Battery charge too low
 Mounting nut of the cutting blade loose
 Cutting blade not properly mounted
 Cutting blade damaged
 Cutting thread torn
 Cutting blade / head / device dirty

Note the following to extend the service life of the device
and to ensure smooth operation:
− Carry out a thorough cleaning and maintenance.

Remove the cutting blade or the thread head to make
cleaning it and the guard easier.
 Check the cutting tool and the guard for damages during
cleaning.
 Apply corrosion protection on the cutting blade.
 Have the cutting blade resharpened if necessary.
− Check the device for perfect condition to ensure reliable
use.

For information on "Storage" of the battery and the charger,
please refer to the respective "Operating Instructions".
Corrective action
 Charge the lithium ion battery
 Insert the lithium-ion battery correctly
 Contact the customer service
 Charge the lithium ion battery
 Contact the customer service
 Turn the cutting blade over or have it
resharpened or replaced
 Replace the cutting thread
 Contact the customer service
 Allow lithium-ion battery to cool down
 Charge the lithium ion battery
 Tighten the mounting nut
 Mount the cutting blade properly; make sure
the cutting blade is positioned correctly in the
recess of the guard
 Replace the cutting blade
 Replace the cutting blade
 Clean
25