Würth 1952 004 230 Traduction Des Instructions De Service D'origine page 5

DE
GB
INTRODUCTION
FR
It is compulsory to read this instruction manual before starting any
kind of action.
NL
The proper operation and full compliance of this product's
performance is guaranteed only if all the instructions provided in this
ES
manual are closely adhered to.
We guarantee that this product complies with the technical
IT
specifications described in this manual.
The manufacturer shall not be held responsible for any improper
uses other than those described herein.
PT
Use protective work gloves, protective footwear, hard hat and safety
goggles.
PL
Misuse:
- This product should only be used as described in this
DA
documentation; any other use is considered improper.
- The manufacturer accepts no responsibility for any
damage caused by the incorrect or unreasonable use of
EL
the equipment.
- Moreover, misuse shall also void the warranty.
Take care of your tools:
- Be sure to store your tools in a clean state.
- Place the tools inside their original package.
Press frame support clamp for pit lifts
Allows the clamping of press frames and C-frame to be placed on
a pit lift (fig. 1).
Greatly facilitates the positioning of the components' press frames
when replacing bearings, bushings, load-bearing joints, etc. directly
on the vehicle.
This tool can be adjusted and rotated. The press frames can be
placed between the jaws.
You can find the reduction adapters to be used with your pit lift, item
code 1952 004 240 (fig. 2)!
Technical data:
Pit lift housing: Ø40mm
Total length: 220mm
METHOD OF PREPARATION
1
2
5