Powering The Case Fans; Installing The Front I/O Connectors; Frequently Asked Questions - Corsair CARBIDE Série 100R SILENT EDITION Guide D'installation

CARBIDE SERIES
®

9. Powering the Case Fans

1. Connect the SATA power
connector to the PSU SATA
power cable.
2. Connect the 3 or 4-Pin
fan connecter to the case
fan header.
3. Push the fan speed selector
button on your case to
toggle fan speed.

10. Installing the Front I/O Connectors

See your motherboard's
manual for front panel header
locations and pin-outs.
USB 3.0
HD AUDIO
9
100R SILENT EDITION
1
2
3
POWER SW POWER LED +
RESET SW POWER LED -

Frequently Asked Questions

1. How do I remove the I/O Panel ?
If needed, you can uninstall your I/O panel by removing the front
fascia (step 5) then unscrewing the 2 screws at each side of panel.
(see drawing)
2. Does the polarity matter with the I/O panel's power and reset header?
No, only the LED headers.
3. Who should I contact if I received my case damaged or one of the
fans is no longer working?
Please go to support.corsair.com and request an RMA
so that we can replace the damaged part(s).
4. Where can I mount a fan?
Fan Mount Locations
Front x2 120mm or x2 140mm
Top
Rear
Bottom
Side
Mid
To learn more about this case visit the product page at corsair.com.
x
120mm
x
x
x
10