6.5.3 Turning on the LEDs
To switch on or off the work surface light or the cup
warmer light, press the
ing push button panel.
Work surface LED
Cup warmer LED
6.5.4 Raised cup grilles
When using cups with different heights, the machine's
special flippable grilles (22) can be used.
To use the grille, unhook it from the latch and rotate
it into a horizontal position.
When it is no longer needed, push it upwards, until
it latches into place.
To clean the grilles, see chapter "8.5.1 General instruc-
tions" on page 77.
USER manual
button on the correspond-
22
Dispensing coffee
6.6
6.6.1 AL version
• Place the coffee cup un-
der the dispensing spout;
• Pull the lever all the way
down;
• Wait a short time for the
coffee to be pre-infused
(3-5 seconds);
• Lift the lever until a cer-
tain resistance is felt, then
release it;
• Wait until the coffee has
been dispensed.
Never perform the above actions without coffee in the filter or
without the filter holder attached to the dispensing group. The
rapid upward movement of the lever may cause damage to the
appliance, individuals or property.
The dispensing time depends on the grinding and the amount of
coffee in the filter holder.
6.6.2 AEP version
• Place the coffee cup under the
dispensing spout;
• Press the desired dispensing
switch. The coffee will begin
being dispensed, and it can be
stopped using the same switch
once the desired amount of cof-
fee has been obtained in the cup.
59
288
of